This one-piece NHRA legal drive shaft safety loop is a bolt-in or weld-in application for the 1964-1972 GM A-body. Drive shaft loop is contoured for the A-Body floor pan and bolts or welds into the reinforcement rib located behind the transmission. This is a must for tracks that require a safety loop for cars running faster than 13.99 in the quarter mile. The entire loop is constructed of 0.250" thick mild steel, CNC machined mounting points for a superb fit and fully MIG welded for outstanding strength. Features: Bolt-in or weld-in design Loop made from DOM tubing, not commonly used electric welded tubing New hardware included Durable long lasting glossy powder coat finish Installation: New hardware and detailed installation instructions included. Bolting the drive shaft loop in requires drilling (4) holes in the vehicles floor pan. Installation process takes 30-45 minutes.

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion needs!

My Cart

1964-1972 GM A-Body Drive Shaft Safety Loop

Customers Also Purchased These Related Items

About

Help

My Account

Contacts