LS2/LS3 rear to front cam sensor extension

APPLICATION: Gen 3/4 LS/Vortec cam sensor extension harness

PARTS INCLUDED: Extension harness

NOTES: This plug and play cam sensor extension harness is designed to extend the cam sensor connection from a gen 3 24X rear cam sensor location to a front timing cover mounted cam sensor location found on gen 4 58x engines and the LS2. This will often be needed on Gen 4 engines converted to drive by cable (DBC) where the cam sensor will be on the timing cover like on factory Gen 4 engines. Factory gen 3 engines have the cam sensor on the back of the valley cover next to the oil pressure sensor. Harness is 48" in length.

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

LS2/LS3 rear to front cam sensor extension

LS2/LS3 rear to front cam sensor extension

Do you have any feedback about our product?

Customers who bought this item also bought

Gen 3 Side knock sensor extension

About

Help

My Account

Contacts