LS Low Mount A/C Air Conditioner Compressor Bracket for Sanden 7176 LS1 Camaro

LS - 4-Rib - Sanden 7176 A/C Compressor Bracket Kit

Mounts the aftermarket style "Sanden 7176" (SD7) compressor down low on the passenger side in the factory LS compressor location

Aligns compressor with the rear, 4-rib belt location on the crankshaft pulley
Compatible with 1998 to 2002 Camaro crank pulley or GTO (ICT# BAL200)
Compatible with LS1 Camaro water pump (ICT# WAT200)
Not compatible with "stock" small block chevy motor mount location, using ICT Billet LS swap plates (ICT# 551628)
Includes: bracket, mounting hardware, and belt tensioner
Made in Wichita, Kansas from aerospace grade, USA produced, billet aluminum

Compatible with (based on vehicle 3D scans by ICT)

Nissan 240SX, S14Â Â 95-98

Belt length (373K4) (37.3 inch) *note this does NOT fit factory style LS vehicle a/c compressors

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

LS Low Mount A/C Air Conditioner Compressor Bracket for Sanden 7176 LS1 Camaro

LS - 4-Rib - Sanden 7176 A/C Compressor Bracket Kit

Mounts the aftermarket style "Sanden 7176" (SD7) compressor down low on the passenger side in the factory LS compressor location