BTR LS PDS STAGE 1 TORQUE CAMSHAFT

BTR PDS STAGE 1 TORQUE CAMSHAFT 217/23X, .619/.607, 114 LSA INTAKE LOBE LIFT @ TDC: 0.03980 This new version of our Stage 1 PDS camshaft makes more power and torque everywhere in the curve compared to our legendary PDS cams. Developed in house, we went back to the drawing board and found more power and torque even with the use of less intake duration.These new BTR lobe designs were Spintron and Engine Dyno tested to achieve the highest overall power curve while also maintaining strict valvetrain stability and durability standards. E85 fuel is highly recommended. The dyno sheet below was with a LS3 short block, GMPP ported LS3 heads, Kong ported LSA supercharger. 17psi boost, E85 fuel. Tested in house on BTR's Superflow dyno.

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

BTR LS PDS STAGE 1 TORQUE CAMSHAFT

BTR LS PDS STAGE 1 TORQUE CAMSHAFT

Do you have any feedback about our product?

Customers who bought this item also bought

About

Help

My Account

Contacts