LS Gen 4 O-ringed Valley Pan Cover Plate for DOD Delete

Low Profile Valley Pan w/ O-ring Seal

Dress up your engine with this great looking billet valley cover

Compatible with Gen IV Engine Blocks LS2 LS3 LS7 LH6 L92 L76 LY2 LY5 LY6 LC9 LFA LH8 LMG L98 L9H L20 L94 LZ1 L99 L96 LC8 L77
No need to drill, tap, and plug DOD oil port in engine block (uses seals built into valley cover to plug these)
Must Relocate Oil Pressure Sensor or use part number 551623 oil port
Made in Wichita, Kansas from aerospace grade, USA produced, billet aluminum
Package Includes: O-rings, Stainless Steel Bolts, and Valley Pan
Machined aluminum finish (tool marks/scratches as shown)

Valley pan bolts are to be torqued to 18 ft/lbs.

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

LS Gen 4 O-ringed Valley Pan Cover Plate for DOD Delete

Low Profile Valley Pan w/ O-ring Seal

Dress up your engine with this great looking billet valley cover