LS Gen 3 Billet Valley Pan Cover Plate (Knock Sensor Delete) LS1

Gen III LS Valley Pan

Compatible With All Gen III Engine Blocks

Will not fit Gen IV Engine Blocks (LS3, LS7, or blocks with Active Fuel Management (AFM), DOD)
Made in Wichita, Kansas from aerospace grade, USA produced, billet aluminum
Includes stainless steel bolts as shown
Natural aluminum finish (minor tool marks/scratches as shown)

Valley pan bolts are to be torqued to 18 ft/lbs.

Does NOT include the gasket (Use gasket part # MS19328 or 12558178 ) (Knock Sensor "doughnut" gaskets are not needed as the knock sensors are deleted with this valley cover)

*Knock sensors are not required to run the engine

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

LS Gen 3 Billet Valley Pan Cover Plate (Knock Sensor Delete) LS1

Gen III LS Valley Pan

Compatible With All Gen III Engine Blocks