LS Gen 4 Valley Pan Cover Plate DOD Delete (requires plugs)

*Compatible with Gen IV Engine Blocks only

Billet Low Profile Valley Cover

Dress up your engine with this great looking billet aluminum valley cover
Compatible with tapping 1/8"npt plugs in all 8 center oil riser lugs or loss of oil pressure will occur (or use part # 551605 valley pan)
Must relocate oil pressure sensor or use ICT part number 551623 (shown in photos)
Compatible with Gen IV Engine Blocks (such as LS2 LS7 LH6 L92 L76 LY2 LY5 LY6 LC9 LFA LH8 LMG LS3 L98 L9H L20 L94 LZ1 L99 L96 LC8 L77)
Made in Wichita, Kansas from aerospace grade, USA produced, billet aluminum
Includes stainless steel bolts
Does NOT include gasket
Machined aluminum finish (tool marks/scratches as shown)

Can be used with Felpro gasket MS96857 (along w/ drilled/tapped 1/8 npt plugs) or use modified MS96871

Valley pan bolts are to be torqued to 18 ft/lbs.

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA and are 100% Computer Quality Tested. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion!

My Cart

LS Gen 4 Valley Pan Cover Plate DOD Delete (requires plugs)

*Compatible with Gen IV Engine Blocks only

Billet Low Profile Valley Cover