This kit includes Dirty Dingo Slider engine mounts for mounting 1997-2013 GM LS engines into your 63-72 C10 2WD trucks using their Factory rubber engine mounts that are pre-cut to fit properly with the Slider mounts.

The Adjustable transmission crossmember bolts into 2WD 1963-1987 C10 C20 Truck's, Blazer's, and Suburban's. This crossmember, in most cases, will bolt to the frame using existing transmission mounting holes. This adjustable crossmember will allow you to run a powerglide, TH350, TH400, 700R4, 4L60, 4L65, 4L70, 4L75, 4L80, 6L80, and 6L90 and adjust the crossmember without drilling any new holes into your frame.

Looking for an Affordable, In Stock, Plug and Play wiring harness for your LS Swap? PSI sells Standalone Wiring Harnesses for GM Gen II, III, IV, & V LS/LT based engines and transmissions. These harnesses include the Gen II LT1/LT4, Gen III (24x) LS1/LS6 and Vortec Truck Engines as well as Gen IV (58x) LS2, LS3, LS7, & Vortec and GEN V LT / ECOTEC3 Engines. All PSI Harnesses are Made in the USA. In addition to wiring harnesses, PSI carries Holley Products, Vintage Air A/C, Dakota Digital Gauges, HPTuners and PCM programming, Fuel Pump Kits, Engine Sensors, Extension Harnesses, Replacement GM connector pigtails and a complete line of hardware to complete your conversion needs!

My Cart

63-72 Adjustable Engine and Transmission Mounting Kit

Customers Also Purchased These Related Items

About

Help

My Account

Contacts